Installation Instructions

Installation Instructions for Wall Mounted Items

You will need the following tools/items:

1.  drill

2.  phillips head screw driver

3.  level

4.  tape meausure

5.  hammer

6.  1 general use nail

7.  3 inch screws

8.  studfinder (if screwing into a stud - which is recommended).

Optional: If not installing into a stud, at least 100 pound wall anchors (ie. toggle bolts)


Tools

 

Toggle Bolts

Meaure your area to find the best place to hang your wall mounted item.

Measure

If you will be screwing into a stud (recommended), find your studs with a studfinder.

Stud Finder

Remove the wooden plugs by taking a small screw and tapping on them from the other end.  See demonstration in video below.   Once you attach your piece to the wall, you will plug up these holes, so that the screws don’t show. 

Remove Plugs

Put your wall mounted item where you'd like it installed on the wall & then make sure it is level (so that you can mark it).

Level

Mark the spots (with pencil) where you will be drilling a hole or installing a wall anchor/toggle bolt.

Mark

If using a wall anchor (or toggle bolt), put coat rack down & install it per the manufacturer's instructions.

Drilling

If you are using a wall anchor (or toggle bolt), use a screw driver to tighten into wall.

Toggle Bolt

Next, install the screw into the stud or wall anchor through the open holes (where you removed the plug).

Screw

Install the plugs back into the open holes.   Gently tapping on them with a small hammer or block of wood is typically most effective.    Here's your finished piece!

Install Complete